How
does the Bull Horn ATM Alarm work?
The Bull Horn ATM Alarm is activated by detecting motion, degree of tilt, light and/or contact switch. The alarm, once activated, will produce an ear piercing 120db siren for 10 hours, or until turned off or reset by keyed switch.
The Bull Horn ATM Alarm can not be disabled and or produce a false alarm from outside the ATM, unlike other ATM alarms on the market that power outages, unplugging the power cord producing false alarms.
Installation
Instructions
- Make sure that the area on the bottom of the ATM’s safe is clean and free of oils, dirt, etc.
- Peel backing off of the double-sided tape from the bottom of the alarm.
- Place alarm in the center of the bottom of ATM and push firmly in place.
- Plug ATM power cord into back of the alarm. (Optional feature and only on BH2000 model.)
- Plug alarm power cord into a 110 Volt grounded power outlet. (Only on BH2000 model.)
- Select alarm settings.
- Turn on alarm.
Operating Instructions
Opening and closing ATM with use of Light Sensor and/or Door Contact Switch.
- Unlock and open ATM door.
(You will hear small chirps from the alarm letting you know that you have 25 seconds to turn off alarm, if you do not, the alarm will be triggered.)
- Turn off alarm with key.
- Fill ATM.
- Turn on alarm with key
(You will hear small chirps from the alarm letting you know that you have 25 seconds to close and lock ATM door. Chirps will stop once the door is closed, then the unit is armed.)
Opening and closing ATM with No use of Light Sensor and/or Door Contact Switch.
- Unlock and open ATM door.
- Fill ATM.
- Lock and close ATM door.
(There is no need to turn off alarm.)
Alarm Settings
- Alarm settings can only be changed or set when the alarm is turned to the off position.
Resetting Alarm
- Turn alarm off with key, wait 3 seconds, then turn alarm back to the on position.
Operating Specifications
Temperature: 40° - 120° F
Relative Humidity: 0% - 95% non-condensing
Power Consumption: 0.2 Amps
|
